Operation Manual

Putting the Units into Operation
26
Connecting the receiver
Attention: Position the receiver with a minimum distance of 1 m to other electronic
devices, otherwise there is a risk of mutual disturbance.
Operating with a power adapter plug
Connect the receiver as illustrated in the diagram. For safety reasons, only use the power
adapter plug supplied.
Mains power outlet
Operation with rechargeable batteries
6. Turn the belt clip upwards.
7. Open the battery compartment on the rear side of the receiver.
8. Insert the batteries, paying attention to correct polarity.
9. Close the battery compartment again.
10. Turn the belt clip back downwards.
The receiver is powered by a 3.7 V, 1800 mAh Lithium−ion polymer battery pack.
The rechargeable battery pack can be recharged directly in the receiver when it
is inserted in the charging station. The Power LED lights up red when the receiver
is being charged. In the case of a low battery charge, the Power LED flashes
slowly. The battery pack must then be recharged.
Using the belt clip/support
You can use the belt clip/support as a belt clip by turning it upwards.
When tuned downwards, it can be used as a support to keep it in a standing position.
Service−Hotline Germany: Tel. [phone], costs via German landline at the time of going to
print: 14 ct/min., max. 42 ct/min. via mobile phone networks