User manual
Page 170
IEI
®
Technology, Corp.
PPC-5170GS Flat Panel PC
C.1 BIOS Configuration Options
Below is a list of BIOS configuration options described in Chapter 5.
System Overview ...................................................................................................84
5
5
9
0
1
1
1
2
3
4
4
4
4
5
5
...................................................................................................96
6
7
8
8
9
9
9
System Time [xx:xx:xx] .........................................................................................8
System Date [xx/xx/xx] ..........................................................................................8
Max CUPID Value Limit [Disabled].......................................................................88
Hyper Threading Technology [Disabled] ............................................................88
IDE Configuration [P-ATA Only]...........................................................................8
S-ATA Running Enhanced Mode [Yes]................................................................90
P-ATA Channel Selection [Both] ..........................................................................90
S-ATA Ports Definition [PO-3
rd
./P1-4
th
.] ...............................................................9
Configure S-ATA as RAID [No].............................................................................90
Hard Disk Write Protect [Disabled] ......................................................................9
IDE Detect Time Out (Sec) [35] .............................................................................9
ATA (PI) 80Pin Cable Detection [Host & Device] ................................................9
IDE Master and IDE Slave .....................................................................................9
Auto-Detected Drive Parameters..........................................................................9
Type [Auto] ....................................................................................................9
ZIP ....................................................................................................9
LS-120 ....................................................................................................9
LBA/Large Mode [Auto].........................................................................................9
Block (Multi Sector Transfer) [Auto]....................................................................9
PIO Mode [Auto] ....................................................................................................9
S.M.A.R.T [Auto] .
32Bit Data Transfer [Disabled] .............................................................................9
Floppy A [1.44 MB 3½”].........................................................................................9
On Board Floppy Controller [Enabled]................................................................9
Serial Port1 Address [3F8/IRQ4] ..........................................................................9
Serial Port2 Address [2F8/IRQ3] ..........................................................................9
Serial Port2 Mode [Normal]...................................................................................9
Parallel Port Address [378] ...................................................................................9