User manual

Page 51
PPC-5170GS Flat Panel PC
JP2 DESCRIPTION
1-2 closed +3.3V (default)
3-4 closed +5V
5-6 closed +12V
Table 3-15: LCD Voltage Setup Jumper Settings
3.6 HDD, FDD and CD Drive Installation
3.6.1 HDD Installation
To install a HDD, please follow the steps below:
Step 1:
Step 2:
Step 3:
Step 4:
Remove the back cover (Section 3.5.1).
The HDD bracket is attached to the elevated platform by four retention screws.
Remove the four retention screws from the elevated platform (Figure 3-2).
Figure 3-2: HDD Retention Screws
Attach the HDD bracket to the HDD. To do this, align the four retention screw
holes in both side of HDD bracket with the retention screw holes on the side of
the HDD. Insert two retention screws into the bracket on both sides of the HDD.
Install the HDD into the PPC-5170 by aligning the retention screw holes in the
base of the HDD bracket with the retention screw holes on the elevated platform.