User manual

Page 56
IEI
®
Technology, Corp.
PPC-5170GS Flat Panel PC
Figure 3-9: CD Drive Blank Plate Assembly
WARNING!
The two screws (black M2*3) shown in the left image of Figure 3-9 are
different from the two screws (silver M2*2) shown in the right. Please
secure the correct screws into the CD drive according to the images shown
in the Figure 3-9.
Step 8:
Step 9:
Step 10:
Slide the CD drive into the PPC-5170 and align the two retention screw holes in
the side of the CD drive bracket with the retention screw holes on the bottom
panel.
Reinsert the two previously removed retention screws.
Connect the CD ribbon cable and the power cable from the connectors on the
motherboard and the PSU to the rear of the CD drive. Figure 3-10 shows a
properly installed CD drive.Step 0: