User manual

Page 62
IEI
®
Technology, Corp.
PPC-5170GS Flat Panel PC
Figure 3-14: Cut the Panel
Step 3:
Step 4:
Step 5:
Slide the PPC-5170 through the hole until the metal frame is flush against the
panel.
Insert the panel mounting clamps into the pre-formed holes along the edges of
the PPC-5170, behind the metal frame. Refer to the mounting kit packing list for
the required number of mounting clamps.
Figure 3-15: Panel Mounting Clamp Positions
Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel (Figure 3-16).
Step 0: