User manual

Page 63
PPC-5170GS Flat Panel PC
Figure 3-16: Tighten the Panel Mounting Clamp Screws
3.7.3 Arm Mounting
The PPC-5170 is VESA (Video Electronics Standards Association) compliant and can be
mounted on an arm with a 100mm interface pad. To mount the PPC-5170 on an arm,
please follow the steps below.
Step 1:
Step 2:
Step 3:
The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 100mm interface pad. If the mounting arm is not VESA
compliant, it cannot be used to support the PPC-5170 flat panel PC.
Once the mounting arm has been firmly attached to its surface, lift the PPC-5170
flat panel PC onto the interface pad of the mounting arm.
Align the retention screw holes on the mounting arm interface with those in the