Operation Manual

- Setting Up -
31
2. Setting up
2.1 Safety notices
NOTICE! Before switching on, do not fail to read the safety notices on of the beginning of
these instructions.
2.2 Checking the contents of the package
The package should contain:
one charger one supply cable
one handset with battery pack one belt clip
one set of directions for use
2.3 Connecting the charger
Set up the AUDIOLINE DECT5501 within reach of a electricity supply socket.
1. Insert the connector on the lead from the transformer plug in the socket on the
underside of the charger and insert the transformer plug in a 230V supply socket
installed in accordance with regulations. For safety reasons, use only the transformer
plug supplied.
2. Press the cable into the cable channel leading to the rear of the charger.
2.4 Exchange the batteries
If you ever have to change the rechargeable batteries, use
only rechargeable batteries, type AAAA 1.2 Volt, 120mA or a
Ni-MH 2.4V, 300mA battery pack. To fit the batteries into a
handset, press down on the upper edge of the battery
compartment cover and slide it downwards. Then carefully
remove the battery holder. Please do not pull too hard on
the battery holder to avoid breaking the connecting wires.
Remove the used batteries and then fit the new batteries
into the battery holder. In doing so, be careful to ensure
that the polarity is correct. When using a battery pack,
please be careful of the contacts on the side and take note
of the inscription on the battery pack. Replace the battery holder in the handset and
close the lid of the battery compartment.
Important notice: Place the handset on the base station, with the display facing
forwards, for at least 16 hours. If the batteries are not properly charged, the telephone
may fail to function correctly. While the handset is charging, the battery capacity symbol
in the display will blink. The indicator lights as soon as the handset is placed in
position.