Operation Manual

- Setting up -
59
3. Setting up
3.1. Safety Information
NOTE: Before setting up, it is essential that you read the General
Information at the beginning of this manual.
3.2. Check contents of pack
The following items are supplied:
one base station one mains power supply
one handset with standard batteries one belt clip
one telephone connecting cable one instruction manual
two screws two wall plugs
one headset
3.3. Connecting the base station
1. Position the base station near to your
telephone connection socket and to a mains
socket. Insert the plug of the power supply
into the socket on the underside of the base
station and plug the power supply into a
properly installed 230 V mains socket. The plug-in power supply for
the base station must always be connected. For safety reasons, use
only the plug-in mains power supply provided.
2. Connect the telephone cable supplied to the
telephone socket and the telephone jack on
the underside of the base station. Use only
the new telephone cable provided.
3. Run the two cables through the clamps and
the two cable channels to the rear of the
base station.