Operation Manual
27
GB
6. You will hear beeping sounds three times
per second, a 'bi' sound twice and a
"beep" sound when the measurement is
finished. The total measurement takes 3
seconds.
7. Read the temperature on the display.
8. A new measurement can be taken after
the ready symbol ( __._ ) is displayed on
the LCD screen.
9. Automatically shuts off after one minute
of non-use.
NOTE
• If there is perspiration on the forehead,
take the temperature from behind the
ear lobe. In this case, disregard point
number 5. All of the other points still
apply.
• Brush any hair aside if it covers the ear and wait approxi-
mately 30 seconds for a more accurate measurement.
Gently place the NFS-100 on the neck directly behind the
ear lobe and scan following the directions of the arrows
over approximately 1 ~ 2 cm of skin as illustrated for 3
seconds.
• You should slide the product until you hear the 'beep"
sound, which indicates the end of the measurement. It can
then be removed from the skin.
• Normally, the artery behind the ear lobe does not provide a
sufficiently accurate reading. However, in the case of a fall
in skin temperature due to sweating, taking the temperatu-
re from behind the ear lobe may give a more accurate rea-
ding.
How to use