Service manual

D - 16 Reassembling the radio June 2003 IPN: M5000-00-105

Figure D-12: Assembly of the switches

Fitting the front panel to the

chassis

Place the radio into the front panel top first,

inserting the antenna connector and knob

switches through the holes. Gently ease the

radio into the front panel until the edge of the

chassis is flush with the edge of the front panel,

while making sure that the seal is not pinched;

using the battery as leverage as in radio disas-

sembly may be helpful. Replace the two chassis

screws at the base of the radio, tightening them

to 2in.lb (0.23Nm).

Replace the two knobs on the radio with new

knobs. Press each knob on firmly. There should

be a small gap between the knob label and the

base of the knob.

shield

chassis

antenna connector

channel selector switch

on/off/volume control switch

ribbed lock washer (M6x10x0.7 mm)

SMA connector nut (¼x7.9x3 mm)

channel/volume control nut

(M6x7.9x3 mm)

knob seal