Operating instructions

- Commissioning -
27
3.9 Wall mounting
Your telephone is also suitable for wall mounting. Use two screws for fixing. Drill
two holes horizontally side by side, 67 mm apart, and leave the screws protruding
from the wall by 5mm. Now place the telephone over the screws and push it
slightly downwards.
There is a small hanging device in the receiver rest to prevent the receiver from
falling when it is placed on the rest with the telephone mounted on the wall. Using
a small screwdriver, turn this hanging device until a small hook appears at the
upper end.
If you are using the telephone fitted to the wall, you can hang the receiver on the
telephone without hanging up. You will find a small hook for this purpose at the
upper end of the receiver rest.
3.10 Setting the day and time announcement
The answering machine always saves the day of the week and the time of day
with each recorded message so that you always know when callers left their
messages.
If you want to enter the day and time announcement for the first time or if you
want to change a day and time announcement that has already been set, please
proceed as follows:
1. Press and hold the
button for 2 seconds. You will hear the day of the
week currently set over the loudspeaker.
2. Press the
button repeatedly until you hear the correct day of the
week.
3. Press the
button. You will hear an announcement of the hour
currently set over the loudspeaker.
4. Press the
button repeatedly until you hear the correct hour
announced.
5. Press the
button. You will hear an announcement of the minutes
currently set over the loudspeaker.
6. Press the
button repeatedly until you hear the correct minutes
announced.
7. Confirm with the
button and the complete day and time
announcement will be repeated.
The day and time announcement can be checked at any time. Simply press the
button and you will hear the day of the week and the current time of
day.
Note: If there is a pause of more than 20 seconds while entering the day and
time announcement, the programming will be interrupted.
If no battery has been fitted or if the battery is discharged, the day and time
announcement must be re-entered if there should happen to be a power failure.