Operating instructions

- Operation Telephone -

4 Operation Telephone

4.1 Using the telephone

The telephone can be used like any conventional telephone.

1. Lift the receiver and wait until you hear a dialling tone.

2. Now dial the required telephone number.

3. To end the call, replace the receiver.

Incoming calls are accepted by lifting the receiver and are ended by replacing the

receiver.

4.2 Adjusting the receiver volume

If the receiver volume is too quiet or too loud for you, you can change this to suit

your requirements.

You can use the slide switch

on the receiver to adjust the

volume from soft

to loud .

4.3 Call Duration Display

The call duration is shown in the display in minutes and seconds during a call. The

indication starts after the number has been dialled. The call duration still remains

showing in the display for a few seconds after the call has been ended.

4.4 Redial

If a connection that you have dialled is engaged or you were unable to get

through to anybody, simply replace the receiver. The last number dialled with a

maximum of 31 digits will be saved in the telephone automatically. To use the

redial facility, proceed as follows:

Lift the receiver and press the redial button

. The saved redial number will

now be dialled.

4.5 Adjustable call tone

You can use the slide switch underneath the telephone to select the settings HI

(high) or LO (low) to adapt the ringer volume to your requirements. Should you

not want to be disturbed, use the OFF position.