Operating instructions

− INSTALLATION −

2 INSTALLATION

2.1 CONNECTING THE RECEIVER

After unpacking your telephone, you must first connect the telephone

receiver to the base unit. The spiral cable needed for this has two identical

connections. First take one end of the spiral cable and plug it into the

socket at the bottom of the receiver. Now plug the other end into the socket

on the left−hand side of the base unit.

2.2 INSERT BATTERY

Before connecting your new telephone to the telephone network, install the

battery enclosed with the telephone. Please always use type AAA 1.5 V

alkaline batteries. The batteries are required for the display and other

features of the telephone. Make sure that the telephone is not connected to

the telephone network, before installing or changing the batteries. The

battery compartment is to be found on the underside of your telephone.

1. Open the battery compartment with a small screwdriver or a pointed

object.

2. Insert the battery. Ensure that the polarity is correct. Push the "−" pole

onto the small spring and then press the "+" pole downwards.

3. Close the battery compartment

Change the battery when the display is no longer visible.

2.3 CONNECTING THE TELEPHONE

Connect the telephone cable provided to the telephone jack and the

telephone socket on the rear of the telephone. The AUDIOLINE Telephone

48 Extra Plus works using the TTD system (Touch−Tone Dialling).