Operating instructions

− THE R" SIGNAL BUTTON −

4.3 DIALLING AND STORING TELEPHONE NUMBERS WHEN

USING ON PRIVATE EXCHANGES

Note!

The pause function after an outside line code (usually 0 or 9) described in

this chapter is only required on older private exchanges.

Some private exchanges use a short pause between the code for the

outside line (usually 0 or 9) and the dialling tone. When dialling manually

and when dialling using the direct dial and speed dial buttons, this pause

can be entered along with the number so that the following digits are not

dialled too quickly.

Entering the pause when dialling manually

Press the d button once between the number for the outside line and the

actual telephone number. The pause will be shown by a "P" in the display.

After connecting to an outside line your telephone will wait for three

seconds before dialling the actual telephone number.

Storing the pause

When storing a number, press the d button after the number for the

outside line and before the actual telephone number. The pause will be

shown by a "P" in the display. When dialling using the direct dial or speed

dial buttons a pause of three seconds will automatically be inserted after the

number for the outside line.