User guide

AUDIOLINE FF895-2 BASE UNIT FUNCTIONS

SETTING THE CLOCK

It is necessary to set the internal clock in the system to the current time. To set the time

do the following:

# Press and hold the [TIME] button until a long beep tone is heard.

# The system will state the weekday currently set. Press [REPEAT] or [SKIP] buttons to

select the day of the week or hold down to automatically advance/reverse.

# Press and release the [TIME] button to set.

# The system will state the hour currently set. Press [REPEAT] or [SKIP] buttons to

select the hour of the day or hold down to automatically advance/reverse.

# Press and release the [TIME] button to set.

# The system will state the minute currently set. Press [REPEAT] or [SKIP] buttons to

select the minute of the hour or hold down to automatically advance/reverse.

# Press and release the [TIME] button again and the clock is set to the current time.

The unit will reset after 20 seconds if no buttons are pressed.

NOTE: The first incoming CND call that leaves a message on the answering

machine will set the correct time, however, it will not set the day, this must be done

manually.