User guide

AUDIOLINE FF895-2 BASE UNIT FUNCTIONS

To record the message (OGM2) do the following:

# Press and hold the [OGM2] button until a long beep tone is heard.

# State your message clearly (maximum 5 minutes).

# To stop recording, press the [STOP] button. The system will then playback the

message for you to check it.

NOTE: If no buttons are pressed for 7 seconds the unit will revert to standby.

The OGM2 message should state that there is no space left in the answering

machine memory for any more messages. OGM2 is used when the memory is full

and also in “announce only” mode.

OGM PLAYBACK

To listen to the outgoing messages that are recorded in the answering machine, do the

following:

TO PLAY OGM1

OGM1 will playback unless the message memory is full.

# Press the [OGM1] button to listen to the OGM1.

# To stop the message, press [SKIP] or [STOP] buttons.

# To pause the message, press [PLAY] button. To resume press [PLAY] button again.

# To erase, press [ESC/DELETE] button.

TO PLAY OGM2

When the memory is full, or when “announce only” mode is selected, OGM2 will play.

OGM2 informs the caller that the memory is full.

# Press the [OGM2] button to check the OGM2.

# To stop the message, press [SKIP] or [STOP] buttons.

# To pause the message, press [PLAY]. To resume press [PLAY] button again.

# To erase, press [ESC/DELETE] button.

NOTE: The pre-recorded messages will be played if you have not recorded your

own OGM’s.