User manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Defining the WP-101 XGA/Unbalanced Stereo Audio Line Transmitter
4
4.1 Installing and Connecting the WP-101 XGA Line Transmitter
Figure 2 illustrates a typical WP-101 installation.
Figure 2: Connecting the WP-101 XGA/Stereo Audio Line Driver
4.1.1 Installing the WP-101 XGA/Stereo Audio Line Driver
To install the WP-101 as illustrated in the example in Figure 2:
1. Using the pre-installed wiring in the wall box opening that connects to the
unbalanced audio recorder, connect the Audio Out unbalanced (R, GND and
L) terminal block to the unbalanced audio recorder.
2. Using the pre-installed wiring in the wall box opening that connects to the
balanced, stereo audio amplifier, connect the AUDIO OUT balanced
1
3. Using the pre-installed wiring in the wall box opening that connects to the
video acceptor, connect the RGBHV OUT terminal block to the component
video acceptor
(L, R+,
R-, GND, L- and L+) terminal block to the balanced audio amplifier.
2
4. Recommended—Ground the wall plate (see
.
Section 4.2
5. Connect the 12V DC power supply to the power terminal block
).
3
1 Both balanced and unbalanced outputs can be used simultaneously
taking care
that the wiring polarity is correct.
2 Either the BNC or terminal block output can be active, they cannot be connected simultaneously
3 Connect the wire labeled + to the +12V connector and the wire labeled – to the GND connector