User manual

Defining the WP-101 XGA/Unbalanced Stereo Audio Line Transmitter
5
5
6. Insert the WP-101 into the wall box opening and secure it using the supplied
screws.
4.1.2 Connecting the WP-101 XGA/Stereo Audio Line Driver
To connect the WP-101 as illustrated in the example in Figure 2:
1. Connect the VGA source to the PC IN connector.
2. Connect the unbalanced stereo source to the AUDIO IN connector.
4.2 Grounding the WP-101 XGA/Stereo Audio Line Driver
Grounding the WP-101 is recommended.
The grounding wire is connected to the rear of the chassis of the unit.
Table 2: WP-101 Grounding
Component Descriptions
# Item
1 M3 x 6 Screw
2 1/8" Toothed lock washers
3 M3 Ring tongue terminal
Figure 3: WP-101 Grounding Components
The grounding screw is used to earth the chassis of the unit to the ground of the
building, thus preventing static electricity from interfering with the product’s
performance.
To connect the grounding to the WP-101 as illustrated in
Figure 3:
1. Crimp the ring-tongue terminal to the building grounding point wire.
(We recommend that you use a green-yellow 18 AWG wire (0.82mm
2
)
crimped with a proper hand-tool).
2. Insert the M3x6 screw through the toothed lock washers and the ring-tongue
terminal in the order shown above.
3. Insert the M3x6 screw (with the two toothed lock washers and ring-tongue
terminal in place) into the grounding screw hole on the rear of the WP-101
and tighten the screw.
4.3 Wiring the AUDIO OUT 8-Pin Terminal Block
The 8-pin spring-loaded terminal block is an easy plug-in connector for attaching
the cable to the audio acceptors.
Figure 4 defines the pinouts for the terminal block.