User manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Defining the WP-101 XGA/Unbalanced Stereo Audio Line Transmitter
6
Figure 4: Audio Out Terminal Block Pinouts
To connect cabling to the terminal block:
1. Strip the insulation from each conductor.
2. Press the conductor into the relevant hole.
The spring-loaded contact automatically grips the conductor.
3. Repeat for each conductor.
To remove a conductor from the terminal block:
1. Press the lever corresponding to the conductor to be removed.
2. While pressing the lever, pull the conductor from the connector.
Note:
• Press the spring-loaded lever only when removing wires, not when inserting
them
• Each conductor should protrude 9 mm (0.35") from its insulation so that it can
be easily connected. To prevent conductors from shorting, ensure that each
wire is fully inserted
4.4 Wiring the RGBVHV OUT 9-Pin Terminal Block
The 9-pin spring-loaded terminal block is an easy plug-in connector for attaching
the video cables.
Figure 4 defines the pinouts for the terminal block.
Figure 5: RGBHV OUT Video Terminal Block Pinouts