User manual

Assigning an EDID
7
7
To insert or remove conductors from the terminal block, follow the instructions in
Section 4.3
4.5 Wiring the Power Connector
.
The power supply connections are illustrated in
Figure 6.
Figure 6: WP-101 Power Supply Connection
To connect the power supply to the WP-101, as illustrated in Figure 6:
1. Strip about 5mm (0.2”) from the insulation of the power supply wires.
2. Insert the wires fully into the connector block taking care that the polarity is
correct.
3. Using a small, flat screwdriver, tighten the terminal block screws to hold the
wires securely in place.
5 Assigning an EDID
The EDID can either be captured automatically by the WP-101 transmitter (see
Section 5.1), or you can set it manually with one of the preconfigured values (see
5.2Section
5.1 Capturing the EDID from a Display Device
).
To capture the EDID from a display device:
1. Using a Philips screwdriver, remove the four screws holding the faceplate to
the PCB assembly.
2. Using a short cable
1
3. Ensure that the rotary switch (see
, connect the PC IN 15-pin HD input connector on the
WP-101 to the XGA connector of the display and turn the display on.
Figure 7) is in position 0. If it is not, use a
small screwdriver to turn it to 0.
4. Connect the supplied 12V DC power adapter to the power terminal block (see
1 For example, Kramer model number C-MGM/MGM-1