Operating instructions

- Fault finding -
35
9. FAULT FINDING
The display is blank.
- Switch the unit on by means of the REC button.
- Check the battery capacity.
- Check that the polarity of the batteries is correct.
No notes are recorded
- Check the setting of the HOLD switch.
- Check whether the maximum memory capacity or the maximum number of notes in an archiv-
ing folder has been exceeded.
- Check the battery capacity.
No notes are played back
- Check the setting of the HOLD switch.
- Check whether there are any recordings in the selected folder.
- Check the battery capacity.
Recordings cannot be heard.
- Check the volume setting.
- If you want to listen to the notes via the inbuilt loudspeaker, then an earpiece or headphones
must not be connected.
- If you want to listen to the notes via another loudspeaker, then the cable must be connected
correctly.
Display message ERROR
- Carry out a reset
- If you have connected a PC via USB, check the cable connection.
Display message REPAIR
- If the batteries should fail during a recording, the message REPAIR will appear in the display
for a certain time in order to repair the recording.
Reset in the case of a fault
Note: All recordings will be erased!
- Remove the battery.
- Replace the battery and hold the ERASE and REC buttons pressed simultaneously for 7
seconds.
- The display will show "AL CLEAR".
- Press the ERASE button again and the reset is complete.