User`s manual

15
6.4 Using Audionet Link
If you connected the CAT to an Audionet pre amplifier via 'Audionet
Link', you can comfortably switch on/off the CAT (and all other units
connected by 'Audionet Link') with the remote control of the pre ampli-
fier.
Please refer to section 'Audionet Link' on page 11 for information on how
to set up the necessary connections.
Note
· Some Audionet devices issue the 'switch on/off' signal to any further
Audionet units daisy chained to their 'Audionet Link' output with a
little delay to avoid all units switching on at the same moment, which
could cause an overload of your mains fuse. Please consult the user's
manual of your other Audionet units on this subject, too.
· Independently from the 'Audionet Link' interface, you can switch
on/off manually your CAT at any time by using the power key on the
front plate or the remote control.
6.5 AutoStart function
If the AutoStart function of the CAT is active, the unit does not stay in
stand-by mode after connecting to mains (e.g. by using the mains switch
on the back panel), but switches on automatically. Use this option to
power on the unit automatically using a timer device. Refer to section 'Set
AutoStart' on page 31 for detailed information how to setup the AutoStart
function.
6.6 Control elements on the front panel
The front panel has four keys to control the CAT (see section 'Overview
front panel' on page 7). With these keys you can control all functions as
well as all setup options to adjust the unit to your preferences (see section
'Setup menu' on page 24).
power Use key to switch on/off the unit (see section 'Switching on
and off' on page 13).
set Push key shortly to navigate through the setup menu (see sec-
tion 'Setup menu' on page 24).
Keep key pushed for longer than two seconds to toggle be-
tween FM and AM reception (see section 'Switching fre-
quency bands' on page 17) or to exit the setup menu (see sec-
tion 'Setup menu' on page 24).