User`s manual

Frequency Input:

FM _ _ _._ _ MHz

Scan mode in order to manually tune with keys above (see section

'Set Mode' on page 29).

· If the search reaches the upper or lower end of the frequency range

without finding a station, the search continues at the corresponding

opposite end of the frequency range maintaining the search direction.

6.10 Manual search

Use keys up and down on the front panel or keys ‡ and ˆ of the

Audionet System Remote Control Harmony One to tune the CAT manu-

ally.

up or ‡ increases the frequency one step. down or ˆ decreases the

frequency one step. The step size is 50 kHz in FM reception mode and

9 kHz in AM reception mode.

Note

· If you reach the upper or lower end of the frequency range, the search

continues at the corresponding opposite end of the frequency range

maintaining the search direction.

6.11 Direct frequency input

In FM reception mode you are able to enter the desired frequency directly

using the digit keys of the optional Audionet System Remote Control

Harmony One.

First, press key # enter to invoke the Direct Frequency Input dialog.

The display shows:

Now use the digit keys on screen 1 of the Harmony One to enter the de-

sired frequency digit by digit from the left to the right. As soon as the last

digit is entered, the CAT tunes to the new frequency. In case you would

like to exit this mode without completing the input just press key # en-

ter again.