User`s manual

8.4 Set Mode

This option selects the function of the keys up and down on the front

panel or the keys Ch+ and Ch- of the Audionet System Remote Con-

trol in normal operating mode.

Press key down or Ch- to enter the Scan mode. The display shows

Scan.

In Scan mode a short keystroke (less than 2 seconds) on up/down tunes

the CAT one frequency step (FM mode 50 kHz, AM mode 9 kHz) in the

corresponding direction for manual search.

Use a long keystroke on up/down or Ch+ / Ch- on the Audionet Sys-

tem Remote Control Harmony One to start the automatic search in the

corresponding direction. The search stops automatically at the next found

station (see section 'Automatic search' on page 17).

Note

· During normal display mode the CAT indicates the Scan mode with

the symbol SC in the upper left corner of the display (see section

'Display' on page 16).

Press key up or Ch+ to enter the Preset mode. The display shows Pre-

set.

In Preset mode a short keystroke on up or Ch+ selects the next preset.

A short keystroke on down or Ch- loads the previous preset.

Note

· During normal display mode the CAT shows the number of the cur-

rent preset in the upper left corner of the display (see section 'Display'

on page 16).

· In case you tuned to a different frequency manually the display

shows – – instead of the preset number.

· You still may start the automatic search with a long keystroke on up

or down.

Tip

· You can switch between Scan and Preset mode much more comforta-

bly using the optional Audionet System Remote Control Harmony

One. Key Preset / Scan on screen 2 toggles between both modes

directly without entering the setup menu (see section 'Screen 3' on

page 38).