User`s manual

Important

• The electrical specifications of your home country must meet the

electrical specifications printed onto the back panel.

• The EPX is a Class I unit and must be earthed. Please ensure a stable

earth connection. The Phase ('hot' pin) is marked 'PHASE' on the

back panel for the mains input.

• Never pull the mains plug while the EPX is switched on! Before you

pull the mains cord off the socket, power down the unit to stand-by

mode.

Only in cases of extended absence – like vacations – or if massive trouble

on the mains power is to be expected you should switch off the EPX from

the mains using the mains switch. To disconnect the unit completely from

mains pull the mains plug.

4.3 Connecting the mother unit

For the connection of the mother unit an EPX-cord with 5-pin or 7-pin

connector is needed. An overview can be found in the following table.

EPX -cord with

5-pin connector

EPX -cord with

7-pin connector

Image of the

connector

Mother unit

DNP, DNA, DNC,

PRE 1 G3

VIP, VIP G2, VIP G3

ART, ART V2,

ART G2, ART G3

PRE 1, PRE 1 G2

CAT

PAM, PAM V2,

PAM G2

MAP, MAP V2

MAP 1

Mains connection of

the mother unit

Needed Not needed Needed

Important

• Do not connect mother devices equipped with 7-pin connectors (ex-

cept MAP, MAP V2, MAP I) to mains! This would compromise the

quality of audio performance. In this case (see table above) only use

one mains cord to connect the EPX to mains, and no mains cord is

needed for the mother device.