User`s manual

25
T
o
tal Time
Track min sec
16 74 : 03
could cause an overload of your mains fuse. First, control output
OUT 1 2 , then OUT 2 3 switched on.
· Independently from the 'Audionet Link' interface, you can switch
on/off manually your ART G2 at any time by using the power key on
the front plate or the remote control.
Important
· In case the option Set AutoOff is set to shut off in 30 min,
the ART G2 shuts down to stand-by mode automatically, if the disc is
stopped or no disc inserted and no key of the front panel or remote
control is used for at least 30 minutes. This function works independ-
ently from a pre amplifier that is connected via 'Audionet Link', i.e.
the ART G2 shuts down automatically even if the pre amplifier is still
switched on (refer to section 'Set AutoOff' on page 56).
6.2 Inserting and removing discs
Open the cover on top of the ART G2 by pushing it to the back using the
handle. Put a disc onto the spindle with its printed side facing up. Fix disc
with included stabilizer ('Puck'). Please make sure that the stabilizer gives
the disc a centred and level position.
Close the disc drawer. The display reads now Close and then Read-
ing disc.... After reading the table of contents the display shows the
number of tracks and the total playing time of the disc in minutes and
seconds:
Stop playback by pressing the key stop on the front panel or key STOP
of the remote control or key < of the Audionet System Remote Con-
trol, before you open the cover. Please wait until the disc stops turning,
before you remove the stabilizer to remove the disc.
As long as the cover is open the display reads Open.
number of tracks
minutes of total
playing time
seconds of total
playing time