User`s manual
Table Of Contents
- Content
- Overview Connections
- Placement and connection
- Additional earth connection
- Audionet Link
- Polarisation of mains plug
- Connecting the external power supply EPS
- Audio/Video-Connections
- First Steps
- Usage front panel
- Audionet System Remote Control
- Setup
- Display
- On Screen Display (OSD)
- Progressive Scan Card
- Security advice
13
Important:
· The Power key is only available for Activities. In Device Mode the Power key
has no function. Even without using an Activity, the user is able to control all
functions of the MAP V2 using the Harmony 785 in Device Mode. The keys
described below to control the MAP V2 refer to the factory default programming of
the Audionet System Remote Control Harmony 785. Understandably, any changes
done to this setup by the user cannot be discussed here.
Tip:
· In order to switch the MAP V2 on/off, without using an Activity, please use the
keys Power On , Power Off and/or Power Toggle screen page 9. Of course,
it is possible to control the MAP V2 without any Activity, but to tap the full
potential of the Harmony 785 you need to configure Activities customized to your
needs (please refer to the separate manual of the Harmony 785).
Note:
· Please read the separate user's manual to your Audionet System Remote Control
Harmony 785. Activities, Devices and Device Mode as well as customizing the
remote control are discussed there.
The Device Mode for MAP V2 comprises a total of 9 screen pages containing all
infrared commands. Screen pages 1 and 2 include the corresponding keys for directly
accessing the input channels of the MAP V2. All keys relevant while listening, you will
find on screen pages 3 to 5. If you want to change any setup options, use keys on page
6. Screen pages 7 and 8 contain commands to setup the parametric digital equalizer. On
page 9 you find the commands to switch the MAP V2 on/off while using the Harmony
785 in Device Mode.
Navigate through a setup menu of the MAP V2:
Press a menu key to enter the corresponding menu option. Details on every menu item
you will find in the following sections. To navigate through the menu items, use the
Ch+ and Ch- keys. Key Ch- has the same function as the set key on the front
panel. To select an option, use Vol+ and Vol- keys. Vol+ works like the up key at
the front panel, Vol- works like the down key.
There are three ways to leave a menu:
1. Press the same menu key again to get back to RUN mode.
2. Press any other menu key to enter a new menu.
3. Wait for approx. 12 seconds without using any key. After this time the MAP V2 goes
back to RUN mode automatically.