User`s manual
Table Of Contents
- Content
- Overview Connections
- Placement and connection
- Additional earth connection
- Audionet Link
- Polarisation of mains plug
- Connecting the external power supply EPS
- Audio/Video-Connections
- First Steps
- Usage front panel
- Audionet System Remote Control
- Setup
- Display
- On Screen Display (OSD)
- Progressive Scan Card
- Security advice
17
Screen page 3
1 Press key Monitor to toggle monitor/effects loop MONITOR IN / OUT 18 . This
loop works for Front channels Left/Right only. It enables you to listen to a recorder
without interrupting the signal source being recorded or inserting effects processors
e.g. equalizers etc. Connect MONITOR OUT to processor inputs and MONITOR
IN to processor outputs.
2 Press key Dyn. Range to enter Dynamic Range menu. Use keys Vol+ and
Vol- to select desired dynamic range:
Maximum: full dynamic range, no compression at all
Standard: medium dynamic range, moderate compression
Minimum: minimal dynamic range, full compression
Note: This menu is only available, if Internal Decoder is set to active.
3 Press key EQ to switch on/off the double precision parametric digital equalizer.
4 Use key Dolby / DTS Mode to enter Decoder Setup menu. Here you select the
desired mode for Dolby Pro Logic IIx und DTS
**
Neo:6. Additionally, you choose
between Dolby Pro Logic IIx and DTS Neo:6 processing on stereo PCM signals in
Listening Modes Audionet D8, 3 Stereo or Phantom. For more detailed
description refer to sections 'Setup' and 'Menu Decoder Setup'.
Note: Navigate through the menu using keys Ch+ / Ch- . Change options
with keys Vol- / Vol+ .
5 Use key PCM Direct to switch activate/de-activate PCM Direct mode. If active,
the name of the currently selected input channel in the display is replaced by
-PCM Direct-.
Note: You can only activate PCM Direct mode, if a stereo PCM signal is
available at the current audio input. While in PCM Direct mode, the internal
decoder (and therefore Bass Manager, any matrix surround processing etc.) is de-
activated temporarily in order to playback stereo PCM material purely as recorded
and without any changes. To leave PCM Direct mode press PCM Direct again.
If a signal other than stereo PCM is detected at the current input, PCM Direct
mode is switched off automatically. The display informs the user with the message
ç 3 OF 9 è
Fri 12:45
MAP V2
1
2
5
6
9
8
7
3
4
Dynamic
Range
Listening
Mode
Dolby /
DTS Mode
PCM
Direct
EQ
Monitor