User`s manual
Table Of Contents
- Content
- Overview Connections
- Placement and connection
- Additional earth connection
- Audionet Link
- Polarisation of mains plug
- Connecting the external power supply EPS
- Audio/Video-Connections
- First Steps
- Usage front panel
- Audionet System Remote Control
- Setup
- Display
- On Screen Display (OSD)
- Progressive Scan Card
- Security advice
20
Screen page 5
1 Press key DigiRec Select to decide which signal is routed to the digital outputs.
Use keys Vol- and Vol+ to select digital input is output at the digital output
jacks DIGITAL OUT 8 independently from the current input channel. The digital
signal is always available in both formats coaxial and optical. To switch off the
digital outputs select No Digital In. Choose option Tied to Dig. In to
route the currently selected digital input to the digital outputs respectively.
2 Press key Dim Display , then adjust the display brightness with keys Vol+ and
Vol- .
Note: During adjustment the display stays at 100% brightness for better
readability. The new selected brightness will be set after returning to RUN mode
my pressing Dim Display again or just waiting for approx. 12 seconds without
any new command input. If the display brightness is set to Off the display is only
activated while making any adjustment in the setup menus. It will switch off some
seconds after the last change of settings.
3 Press key Digital Filter to select the digital filter. Use keys Vol- and Vol+ to
choose between 4 different oversampling filters for the front channels Left/Right:
Audionet: special digital oversampling filter with short pre-ringing
Lagrange: short Lagrange filter
Blackman: digital filter by Blackman
Kaiser: digital filter by Kaiser.
Note: This option is only available for sample rates up to 48 kHz and not for
DVD Audio using the HighBit interface.
4 Use key OSD to switch on/off the On Screen Display (OSD) of your MAP V2. This
key has the same function as key Guide of the Harmony 785.
Note: The OSD is only available at video outputs VIDEO OUT 1 (in Cinch
Video and S-Video format).
5 Press key Load Setting to re-load previously saved user settings. Select the user
setting you like to load by using the keys Vol- and Vol+ . Press Mute to load
selected user setting. All current settings will be overwritten during load.
You can choose a name up to 14 characters in length for each of the 30 user
ç 5 OF 9 è
Fri 12:45
MAP V2
1
2
5
6
9
8
7
3
4
Dim
Display
Save
Setting
Load
Setting
OSD
Digital
Filter
Digital Rec
Select