User`s manual

21
settings. To change a name press key Ch+ . A cursor marks the character to be
changed by pressing Vol- or Vol+ (see also Edit Channel Name). Move
cursor one position to the right by pressing Mute . While the cursor is active, you
get to the names of the other user settings with keys Ch+ and Ch- . To leave edit
mode press Load Setting again.
6 To save the current settings as user setting press key Save Setting , and choose
one of the 30 memory spaces with the Vol- and Vol+ keys. All data at the
corresponding memory location is overwritten by the current settings after pressing
the Mute key.
You can simply assign the current user setting to only one input channel or even to
all input channels at once. Press Ch+ and select the input channel with Vol- or
Vol+ . Then press Mute to transfer the current settings to the selected input
channel.
Press Ch+ again to enter mode to assign current settings to all input channels.
Press Mute to start data transfer.
A user setting comprises: Volume and balance levels of all output channels,
PCM Direct mode status, dynamic range, Dolby Pro Logic IIx and DTS Neo:6
mode, Listening Mode and Digital Filter. 30 memory locations for storing user
settings are available. The user can assign a name up to 14 characters in length to
each user setting. Additionally, each of the 12 input channels saves automatically
all current settings independently (channel settings). The 30 memory locations (user
settings) can only be accessed by the user when using the Save Setting
function. So they are independent from the channel settings.
Note: Current master volume, speaker settings, state of internal decoder, video
options etc. are saved automatically and independently when changing a setting
and/or switching off the MAP V2.
Note: After adjusting the volume levels of all output channels we recommend
to save these found settings to all input channels as a simple start up for further
channel or source dependent level settings. To save the current level settings to all
input channels press the following keys:
Save Setting à Ch- à Mute
Now all input channels have the same volume level settings. Of course, you can
change these settings easily for each input channel independently, if necessary.
7 Number of current screen page and total number of pages
(example: '5 OF 9' ® screen page 5 of 9).
8 Skips back to the previous screen page (see user's manual Harmony 785).
9 Advances to the next screen page (see user's manual Harmony 785).