User`s manual
Table Of Contents
- Content
- Overview Connections
- Placement and connection
- Additional earth connection
- Audionet Link
- Polarisation of mains plug
- Connecting the external power supply EPS
- Audio/Video-Connections
- First Steps
- Usage front panel
- Audionet System Remote Control
- Setup
- Display
- On Screen Display (OSD)
- Progressive Scan Card
- Security advice
23
pressing one of the 8 keys invokes the setup mode for the equalizer. Then the keys have
the following functions:
Key Ch- selects the next channel, key Ch+ the previous channel. While in the
equalizer setup mode you are still able to adjust the master volume using keys Vol- /
Vol+ .
Leave the equalizer setup mode by using one of the other setup menu keys. The
MAP V2 then enters the corresponding menu. If you wait for approx. 12 seconds
without pressing any key, the MAP V2 will return to RUN mode automatically.
1 MPE- selects the previous MPE
*)
filter of the current channel.
2 MPE+ selects the next MPE filter of the current channel.
3 Freq- decreases the center frequency of the current MPE filter.
4 Freq+ increases the center frequency of the current MPE filter.
5 Number of current screen page and total number of pages
(example: '7 OF 9' ® screen page 7 of 9).
6 Skips back to the previous screen page (see user's manual Harmony 785).
7 Advances to the next screen page (see user's manual Harmony 785).
*)
MPE = Minimum Phase Equalizer
ç 7 OF 9 è
Fri 12:45
MAP V2
5
6
9
8
7
3
4
Freq+
MPE+
Freq-
MPE-