User`s manual

34
Use buffered input, if the output impedance of a source connected to the 8-ch. analog
input is greater than 100 Ohms.
Note:
· If you connect Audionet devices to the 8-ch. analog input, the input signals do not
need to be buffered. In this case use option direct.
Dolby D EX Mode:
Use keys Vol- and Vol+ to select, if for Listening Mode Surround, Dolby
Surround EX encoded bitstreams are recognized and played back in Dolby Digital EX
mode automatically, or if they are played back like plain Dolby Digital bitstreams:
auto on: The 'Dolby Surround EX encoded' flag in the bitstream is recognized
and the playback mode is set to Dolby Digital EX automatically.
never on: The 'Dolby Surround EX encoded' flag in the bitstream is ignored. The
bitstream is decoded in Dolby Digital mode.
Note:
· This setting refers to Listening Mode Surround only! For Listening Mode
Audionet D8 all Dolby Digital bitstreams are decoded as Dolby Digital +
Pro Logic IIx independent from the flag Dolby surround EX encoded. The
user settings of function Dolby Pro Logic IIx Mode for Multi-
Channel apply (see above). See also table 'Overview Listening Modes'.
Menu Video Setup
This menu adjusts global video options for the MAP V2, which are saved automatically
when switching off the unit to stand by mode and re-loaded automatically when
switching on. Select the Video Setup menu by pressing key Video Setup .
LipSync Delay:
While using video processors in projectors, progressive scan modules etc. the video
signal may be delayed in reference to the audio signal, so that picture and sound are not
in sync any longer. Use keys Vol- / Vol+ to adjust a delay of the audio output of the
MAP V2 to get picture and sound in sync again. The delay can be adjusted from 0 to
100 msec in steps of 0.5 msec.
Note:
· Adjusting the LipSync delay does not affect the delay settings of each output
channel relative to each other. It is only for synchronising picture and sound.