User`s manual

38
Display
While in RUN mode the first line of the display provides the number of the input
channel (1 to 6 for Analog In 1 to 6, 1 to 5 for Digital In 1 to 5, E for 8ch External
Input) followed by the (user definable) channel name (14 characters long). If the
monitor/effects loop is active, its name is only 12 characters long. To inform the user of
the activated monitor/effects loop an M is printed in the upper right corner of the
display.
If the internal decoder is inactive (Internal Decoder = disabled), the volume
is displayed in the second line as LEVEL –xx+y dB with xx = current volume and
y = offset adjust for the current input channel. If the internal decoder is active, the
second line changes to MASTER –xx dB with xx = current master volume of all
channels. So the user can easily see, if the internal decoder is active or disabled.
If using a digital input, the first line of the display will show Out of lock while
there is no valid digital signal at the current input. If a valid signal is detected by the
digital receiver, the second line changes to Receiver locked for a moment. Is the
internal jitterkiller active, the display shows Jitterkiller engaged. After that
information about program format, output and speaker configuration follows. Press
Info key at any time to force the display to show this information. After some
seconds, the display returns to showing volume information.
Every program format, the current decoding and output format is displayed as the
following:
Example:
Dolby D+PLIIx Mov
2/0.0 48k 448kb
Current decoder mode
Bitrate of input
signal
Sample rate of
input signal
Program format of
input signal
Dolby D+PLIIx Mov
LCR LSLBRBRS SUB
Current decoder mode
Speaker configuration and
output format