User`s manual
Table Of Contents
- Content
- Overview Connections
- Placement and connection
- Additional earth connection
- Audionet Link
- Polarisation of mains plug
- Connecting the external power supply EPS
- Audio/Video-Connections
- First Steps
- Usage front panel
- Audionet System Remote Control
- Setup
- Display
- On Screen Display (OSD)
- Progressive Scan Card
- Security advice
39
The first line shows information about the current decoder mode:
Display Decoder mode
Test Tone on
Test tone generator is active
Stereo PCM input signals
PCM 2-Ch Stereo
2-channel PCM is played back as stereo signal
A/D conv 2ch
Analog-to-Digital-converted stereo signal
Dolby PLIIx Movie
Dolby Pro Logic IIx in Movie mode
Dolby PLIIx Music
Dolby Pro Logic IIx in Music mode
Dolby PLIIx Matrx
Dolby Pro Logic IIx in Matrix mode
Dolby Pro Logic
Dolby Pro Logic IIx in Pro Logic mode
DTS Neo:6 Cinema
DTS Neo:6 in Cinema mode
DTS Neo:6 Music
DTS Neo:6 in Music mode
Bitstream input signals
Dolby Digital
Dolby Digital
Dolby Digital EX
Dolby Digital EX
Dolby D+PLIIx Mov
Dolby Digital with Pro Logic IIx in Movie mode
Dolby D+PLIIx Mus
Dolby Digital with Pro Logic IIx in Music mode
Dolby D+PLIIx Mtx
Dolby Digital with Pro Logic IIx in Matrix mode
Dolby Digital + PL
Dolby Digital with Pro Logic IIx in Pro Logic mode
Dolby D 2-ch St
Dolby Digital played back as 2-channel stereo signal
D T S
DTS Digital Surround
DTS-ES Discrete
DTS-ES Discrete
DTS-ES Matrix
DTS-ES Matrix
DTS+Neo:6 Cinema
DTS with Neo:6 in Cinema mode
DTS+Neo:6 Music
DTS with Neo:6 in Music mode
DTS 96/24
DTS 96/24
DTS 96/24 + D8
DTS 96/24 with Audionet D8
DTS 2-ch Stereo
DTS played back as 2-channel stereo signal
Input signals via Audionet HighBit interface
Audionet HighBit
MAP V2 receives audio data via the Audionet HighBit interface
from an Audionet source (e.g. VIP G2 or ART G2)
On the left of the second line the program format of the input signal is displayed by
m/n.x, with m = number of front channels, n = number of surround channels and x =
1, if LFE channel (Low Effects Frequency channel) available or x = 0, if LFE is not
available in the program material.
While receiving digital input signals, the current sample rate (in kHz) is shown in the
middle of the second line.
If the input signal is a bitstream (like Dolby Digital or DTS), the current bitrate is
displayed as kbps (kbit per second) in the lower right corner of the display. In case of a