User`s manual

40
PCM input signal information about the usage of emphasis during recording is shown
instead of the bitrate:
EMPH recorded using emphasis
– no emphasis used.
After several seconds the display changes. Now the second line provides information
about the output and speaker configuration. If a speaker is available in the current
speaker configuration, and it is supported by the current Listening Mode, the
corresponding letter is printed in the display:
L = Left Front
C = Center
R = Right Front
LS = Left Surround
RS = Right Surround
BL = Back Left
BR = Back Right
BC = Back Center, if only one speaker is available in the channel group Back
If a speaker is used by the program material, the corresponding letter is printed
inversely in the display.
If the subwoofer is active, it is displayed by an inverse SUB. Otherwise this symbol is
not printed.
Note:
· Is the brightness set to Off the display is only on during setup adjustments,
switching on/off and adjusting the volume. It switches off automatically several
seconds after the last user entry.
· The MAP V2 activates the 'display saver' automatically after 10 minutes without
any user entry.
· During active 'display saver', the display shows only the number of the currently
selected input channel and the volume (e.g. An1 -34dB). The display brightness is
always reduced to 25%, and the location of the information text will change
randomly every 12 seconds to prevent any 'burn-in' effect of the display. If the
MAP V2 is muted, the text mute will replace the volume value. Error message will
be abridged.
· The 'display saver' is de-activated and the display returns to its normal mode as soon
as any user entry is detected.
· The user cannot switch off the automatic 'display saver' function!
· Use key Info of the remote control to display all current information and return to
normal display mode.