User`s manual

44
This unit must be earthed.
Audionet EPS only.
monitor
N
E
G.
left
ANALOG OUTPUTS
VIDEO OUTVIDEO IN
IN 3 IN 4 IN 2
IN 1
S-VIDEO 1 S-VIDEO 4
S-VIDEO 3S-VIDEO 2 S-VIDEO 1
S-VIDEO 2
OUT 1
OUT 2
VGA
Y/R
/G
/B
C
C
R
B
DIGITAL
OUT
(OSD)
(Vsync) (Hsync)
IN
IN
IN
OUT OUT
OUT
OUT
OPTICAL
Note:
· Many units use a SCART connector to provide the RGB video format. In this case,
please use a suitable adaptor from SCART to 'RGB with Sync'. The Sync signal is at
pin #19 of the SCART connector, the colour signals are at pin #15 = R, Pin #11 = G
and Pin #7 = B.
Connection diagram RGB+sog Video In:
If your video source has a RGB video output with the Sync signals provided on the
Green line (Sync On Green), connect the three lines R, G+Sync and B to MAP V2
according to the diagram:
R G B from video output of video source
+ Sync
Video outputs Progressive Scan Card:
The output signal of the Progressive Scan Card is available at video outputs 1 or 2 .
The user can choose between the two output video formats YUV and RGB by menu
setup. The selection works on both video outputs 1 and 2 .
If you are on screen page 6 of the device menu MAP V2 of the remote control, press
keys:
Video Setup à Ch+ à Ch+
to get to function Set Progressive Output. Now use keys Vol- and Vol+ to
select desired video output format:
Y U V Video outputs 1 and 2 provide a progressives Component or YUV signal
(refer to connection diagram below).
R G B Video outputs 1 and 2 provide a progressive RGB signal.
Note: Before you can use the RGB video output, you have to select the
correct output mode for the Sync signals (please refer to connection diagram
and detailed description below)!