User`s manual

45
This unit must be earthed.
Audionet EPS only.
N
E
G.
left
ANALOG OUTPUTS
VIDEO OUTVIDEO IN
IN 3 IN 4 IN 2
IN 1
S-VIDEO 1 S-VIDEO 4
S-VIDEO 3S-VIDEO 2 S-VIDEO 1
S-VIDEO 2
OUT 1
OUT 2
VGA
Y/R
/G
/B
C
C
R
B
DIGITAL
OUT
(OSD)
(Vsync) (Hsync)
IN
IN
IN
OUT OUT
OUT
OUT
OPTICAL
Important:
· Only for the RGB video output mode it is necessary to select the correct Sync output
mode using function Set Video Out. If you are on screen page 6 of the device
menu MAP V2 of the remote control, press the following keys to enter the function:
Video Setup à Ch+
Now use keys Vol- and Vol+ to select desired option:
Composite Video outputs OUT1 and OUT2 7 provide the (Composite-)Video
signal from one of the video inputs IN1 to IN4 (default function
without Progressive Scan Card).
C-Sync Video output OUT2 provides the C-Sync (Composite-Sync) signal for
RGB video output with C-Sync. Video output OUT1 has no signal in
this mode.
H/V-Sync Video output OUT1 provides the V-Sync (Vertical Sync) signal and
OUT2 the H-Sync (Horizontal Sync) signal for RGB video output with
separate Sync signals.
Note:
· Please consult the user's manual of your video display (projector, video beamer,
plasma TV etc) connected to the MAP V2 to decide which video output format is to
be used!
Connection diagram YUV video output:
If your video display has a video input for progressive Component or YUV video
signals, connect the MAP V2 according to the following diagram:
U Y V to video input of video display (3x Cinch)
alternative connection to video input of
video display (VGA)
Pinning: Pin #1 = U
Pin #2 = Y
Pin #3 = V
VGA
YUV