User`s manual

5
Placement and connection
Important:
· Please read this manual prior to operating the MAP V2 in order to avoid
damage on your valuable equipment.
Also, please make sure all units of your audio/video system are switched off while
connecting or disconnecting any cables to avoid damage of the input and/or output
sections of your units.
Please make sure that your Audionet MAP V2 is installed at a place that is sufficiently
ventilated to allow the heat to leave.
The mains input 23
*)
is located at the back panel of the MAP V2. Please use the
provided power cord to connect the MAP V2 to mains. If you want to use a different
power cord make sure that it meets the specifications for your home country.
Important:
· The electrical specifications at the back must meet the specifications of your
home country.
· The mains switch at the back panel has to be switched off before connecting the
MAP V2 to mains. The MAP V2 is a Class I device and must be earthed. Please
ensure a stable earth connection. 'Phase'/'Hot pin' is marked at the back panel
(phase) 23 .
The MAP V2 is a stand by device. Please use the mains switch 23 at the back panel to
switch on the MAP V2. The display shows a welcome message for a brief moment.
After that the MAP V2 is in stand-by mode. The display will indicate the stand-by mode
either with the text off or a small dot (see section 'Set OFF/Standby-Text' on page
21).
Only in case of extended absence (like vacations) or if massive trouble on mains power
is to be expected you should disconnect the unit from mains. Switch off the MAP V2
with the mains switch at the back panel 23 . The display will go out.
Important:
· Before switching off the mains switch of the MAP V2, please make sure that all
units connected to the outputs of the MAP V2 are switched off, too.
__________
*) see numbers on page 'Overview of connections'