User`s manual

6
Additional earth connection
Optionally, there is a special cord available for an additional earth connection to be used
with earth connector 21 . Use the screw of earth connector 21 to connect the
additional ground cord to the MAP V2. Put the plug of the ground cord into a mains
socket near your power cord. The sound will be improved.
Tip:
· We strongly recommend using the additional earth connection!
Audionet Link
In connection with other Audionet devices like AMP I, AMP II, AMP II MAX, AMP
III, AMP IV, AMP VII etc. your MAP V2 is able to switch on/off the complete system.
Please connect a Toslink plastic fibre cable from the Audionet-Link Output 20 at the
back of the MAP V2 to the Audionet-Link inputs of other Audionet devices. For further
instructions please read the user's manual of the other Audionet devices.
Polarisation of mains plug
The correct polarizing of mains is important for reasons of audio clarity and stability.
Therefore the Audionet MAP V2 indicates a wrong polarisation of the mains lead.
While powering up, the MAP V2 checks the mains polarisation. If you read
Attention: Mains Phase incorrect! switch off the MAP V2 and then flip
the plug in your wall outlet.
Connecting the external power supply EPS
Use the provided special cord to connect the optionally available EPS to the EPS-Input
22 at the back panel of the MAP V2. Connect both (!!) units (MAP V2 and EPS) with
mains. Switch on first the EPS then the MAP V2. The unit is now in stand by mode.
To disconnect both units from mains please switch off first the MAP V2, then the EPS.
Before switching off the MAP V2, make sure it is in stand by mode by pressing the
power key at the front panel or the key Power Off or Power Toggle on the
remote control.