User`s manual
Table Of Contents
- Content
- Overview Connections
- Placement and connection
- Additional earth connection
- Audionet Link
- Polarisation of mains plug
- Connecting the external power supply EPS
- Audio/Video-Connections
- First Steps
- Usage front panel
- Audionet System Remote Control
- Setup
- Display
- On Screen Display (OSD)
- Progressive Scan Card
- Security advice
8
External 8-Channel Analog Inputs:
Plug in analog multi channel sources (external decoder, DVD-Player with internal
decoder, SACD-Player etc.) into the 8-channel analog input 11 of the MAP V2.
Note:
ยท The External 8-Channel Analog Input has no signal processing at all, only pure
analog volume control!
Analog Outputs:
The output of the front channels L/R 19 (Cinch and XLR) are marked main line out or
main right/main left and are located in the lower left part of the back panel. All other
analog outputs 12 are located in the section ANALOG OUTPUTS in the upper right
part of the back panel. For Center and Subwoofer channel are two outputs available
each carrying the same signal.
Digital Outputs:
Select DigiRec Select in the setup menu, which digital input 2 to 5 10 is routed to
the digital outputs 8 . Both formats (optical and coaxial) are always available. The
digital record select works independently, therefore you can use digital out for
recording while listening to a different source.
Video Inputs:
Plug in your cinch/composite video sources into video inputs IN 1 to IN 4 3 . S-Video
sources are to be connected to video inputs S-VIDEO 1 to S-VIDEO 4 4 . Use the
video inputs in any order as every one of the 8 video inputs can be assigned to every
audio input (see menu Channel Setup). Even multiple assignments are allowed, i.e. one
and the same video input can be assigned to more than one audio input.
Video Outputs:
The video signal assigned to the current audio input is available at the VIDEO OUT
jacks; cinch video at OUT 1 or OUT 2 7 and S-Video at S-VIDEO 1 or S-VIDEO 2
6 . All video signals at the cinch video inputs are converted to S-Video format by the
internal 'Cinch Video to S-Video Converter' and available at the output S-VIDEO 1.
The On Screen Displays (OSD) is only available at video outputs OUT 1 and S-
VIDEO 1 5 . In order to prevent unintentional recording of the OSD picture, please
connect your video recording device to video outputs OUT 2 or S-VIDEO 2 as they
never carry the OSD signal.
Further Video In-/Outputs:
A video signal at video output VGA OUT 1 is only available, if you have installed the
optional Progressive Scan Card. Without Progressive Scan Card video inputs Y/R, Cr/G
and Cb/B 2 are decoupled from the corresponding outputs by 0dB-gain video
amplifiers. Connect your DVD-Player and projector to the corresponding in-/outputs.