Operation Manual

ENGLISH
DIGITAL-2 - 2-channel DJ mixer with 1 mic and 2 USB ports
Page 5
1 - Mic Level
Adjusts the microphone volume.
2 - Treble (microphone channel)
Adjusts the trebles volume of your microphone.
3 - Bass (microphone channel)
Adjusts the low frequencies volume of your microphone.
4 - PHONO / LINE / USB Switch
Source selector. Channels 1 and 2 feature this function.
5 - Gain
Gain control settings. Channels 1 and 2 feature this
function.
6 - Treble (channels 1 and 2)
Adjusts the trebles volume of channels 1 and 2. Settings
from -15 dB to +15 dB.
7 - Mid (channels 1 and 2)
Adjusts the medium frequencies volume of channels 1
and 2. Settings from -15 dB to +15 dB.
8 - Bass (channels 1 and 2)
Adjusts the low frequencies volume of channels 1 and 2.
Settings from -15 dB to +15 dB.
9 - Master
Adjusts the main volume output.
10 - Phone Level
Adjusts your headphones volume.
11 - Faders (channels 1 and 2)
Adjust the post-equalization output of channels 1 and 2.
12 - VU meter
Channels 1 and 2 LED volume indicator. Try to get sound
levels close to 0 dB to avoid signal distortions.
13 - Cross Fader
Allows you to combine channel 1 signals with channel 2
signals. it is regarded as wearing part and can be easily
dismantled and replaced.
14 - Phone
Allows you to monitor channels 1 and 2 signals via your
headphones, even if faders (11) are at their lowest.
How to monitor:
1 - Two monitoring modes: Split / MIx selector
- Split mode: The phone output is mono: position it on
the left side to monitor channel one and on the right
side to monitor channel 2.
- Mix mode: The phone output is stereo and allows
you to monitor both channels at the same time.
2 - Fader: Adjusting the monitoring sound levels
for each channel
- Push it towards the right to increase channel 2
volume and decrease channel 1 volume.
- On the other hand, push it towards the left to
increase channel 1 volume and decrease channel
2 volume.
15 - Phone output
Stereo Jack 6.35 chassis: connect here your headphones.
16 - Microphone input
Mono Jack 6.35 chassis: connect here your dynamic
microphone.
17 - TALK-OVER Switch
This switch allows you to choose one of the 3 TALK-
OVER modes.
1 - ON: The music volume is decreased by 10 dB.
2 - TALK-OVER: The music level is decreased by 10
dB only when a microphone signal is detected.
3 - OFF: the microphone channel does not prime and
the music level is not altered.