Operation Manual

ENGLISH
DIGITAL-2 - 2-channel DJ mixer with 1 mic and 2 USB ports
Page 6
- Rear panel
1 - Grounds
Connect here the grounds of your turntables.
2 - Line/Phono Switches
Allows you to select which can of sources you want to
connect to the Line1/Phono1 and Line2/Phono2 inputs.
3 - Phono 1 and 2 inputs
Phono inputs if switches (mentioned previously) have
been put in phono mode, allowing you to connect
turntables.
If switches are positioned on Line, they become line-level
inputs.
4 - Line 1 and 2 inputs
Allow you to connect line-level sources such as CD
players, cassette players, wireless microphone receivers,
keyboards, etc.
5 - Master Out
Unbalanced output allowing you to connect your
DIGITAL-2 to an amplifier, active filter, etc.
1
2
3456
7
8
9
6 - External power supply connector
Connect here the supplied power cord, then connect the
other end to an electrical outlet. Please make sure the
voltage delivered is 230V - 50 Hz.
7 - USB1 Connector
Allows you to connect a computer equipped with USB
ports. Your DIGITAL-2 acts as sound card and need a
few moments to get recognised by your computer. Once
identified, your DIGITAL-2 will be considered as audio
device by your computer.
Please refer to the end of this guide for more details
about USB ports and mixing desks.
8 - USB2 Connector
Similar to USB1.
9 - Power switch
Activates or deactivates your DIGITAL-2.