User`s manual

DJAP-612PB DJAP-615P

3.3.USB-MP3 player section

29. USB PORT

For connecting with USB memory.

30. SD CARD PORT

For connecting with SD CARD memory.

31. PRE

In pause state, press this button it will go to the previous song and keep in pause state. In play+ state, press this button it will

go to the previous song and start playing.

32. NEXT

In pause state, press this button it will go to the next song and keep in pause state. In play state, press this button it will go to

the next song and start playing.

33. REPEAT

Press this button the player will change between the following four modes. REP ALL means to repeat all songs in the memory,

the mark on the LED is

ALL

. REP1 means to repeat one song, the mark on the LED is

.Play in order means to play the songs

according to the order, the mark on the screen is blank. Random play means to play the songs at random, the mark on the screen

is A.

34. PLAY/PAUSE

In play state, press PLAY/PAUSE button to pause the player. In pause state, press PLAY/PAUSE button to start playing.

35. STOP

In play state, press STOP button to stop playing and the whole quantity of MP3 songs in the USB memory will display on the

screen. In stop state, press the PRE/NEXT button or press the STOP button again to go to the first song and the player will keep

in pause state, then press down the PLAY/PAUSE button to play it.

36. POWER

When the unit is off, press this button hold for about 2 or 3 seconds to turn on the power supply of the player. Repeat the above

operation, you can turn off the power supply of the player.

37. USB OUTPUT

With this switch, the signal of USB can be selected to input in to CH4 or to TAPE.

3.4 REAR PANEL

38. POWER ON/OFF Switch

This switch is used to turn the unit on/off.

39. AC INPUT

Standard IEC receptacle, connect your DJAP to the main electrical outlet with the supplied power cord.

40. VOLTAGE SELECTOR

There are two kinds of voltages for your operation from this switch, you can select the voltage at 115V or 230V.

41. DC POWER Switch

Connect the AC supply and turn the DC power switch on, the battery can be charged.