Installation manual

4-3

For more information call your Leviton representative or the Leviton Technical Hotline at 800-722-2082

Installation Manual

signal level of 0 dBmV to 15 dBmV. The signal level at

the demarcation point will dictate whether a video

amplifier is required prior to video splitters.

If CATV is available, check to see if cable modems are

available for high-speed internet access. Some cable

modem providers want a direct run from the CATV

demarcation point to the location of the cable modem.

A TV antenna and/or DSS antenna and provision for

DSS distribution throughout the home from the SMC is

not just an alternative to CATV. Your planning and

installation should include provisions for DSS even

though CATV is available. Many homeowners want

either an alternative to CATV, or both CATV and DSS

services. HDTV reception may also need to be con-

cidered. The DSS antenna may require one, two, or

four RG-6 quad shielded cables to the SMC, and from

there to DSS receiver locations. Most RG-6 quad shield

cables for video and TV distribution within the home

use a copper clad steel core to provide optimum video

signal performance and cable strength. But for the

coaxial cable that connects the satellite antenna to the

satellite receiver, many DSS manufacturers recom-

mend solid copper core RG-6 quad shield because the

cable must carry power (voltage switching) to switch

LNBs at the antenna. Make sure you understand the

requirements for your installation. Also, a telephone

jack is required at each DSS receiver location. An off-

air TV antenna may require one or two cables to the

SMC and from there to TV locations. Please note the

possible covenant restrictions on antennae locations in

4.2 above. When planning external antennae or satel-

lite dishes, make sure to take all necessary grounding,

mounting, and lightning protection precautions that

may be required in your region.

ORDINANCES

Local

Ordinances,

Covenants, and

Service Provider

Coordination