Installation manual

ManualsBrandsAudioplex ManualsConsumer electronics25 VOLT STEREO VOLUME CONTROL

8-12

For more information call your Leviton representative or the Leviton Technical Hotline at 800-722-2082

PRE-WIRE

Installation,

Labeling and

Documentation

Pre-Wire

Installation

TELEPHONE DISTRIBUTION MODULE:

1. Run cable into enclosure from telephone demarcation point. 2. Punch pairs down using industry standard 110 tool; (A)wht/bl - blue

pair/line one; (B)wht/or - orange pair/line two; (C)wht/gr - green pair/line three; (D)wht/br - brown pair/line four. 3. All three columns are

now active with dial tone, use patch cords to link whichever line you need to the outgoing port on the Category 5 Voice/Data Module.

CATEGORY 5 VOICE/DATA MODULE:

1.Terminate (by punching pairs down with an industry standard 110 tool) individual outlet cables, one per connector. Label cables to

identify locations they run to. Use “Cabled to” section to identify which Category 5 or 5e port corresponds to which cable. 2. Use patch

cords to link the Category 5 or 5e ports to the Telephone Distribution Module or to a Network Hub.

BRIDGED VOICE MODULE:

1. Run cable into enclosure from telephone demarcation point. 2. Punch pairs down using industry standard 110 tool starting with the

blue pair/line one. 3. Telco line is then bridged on the matching color only, to all remaining connectors on the module. 4. Terminate

individual outlet cables, one per connector, on lower 9 bridged connectors. Label cables to identify locations they run to. Use “Cabled

to” area for additional cable identification.

WIRING IDENTIFICATION CHART FOR CATEGORY 5 or 5e CABLES

Instructions: Label every cable that enters the enclosure and record in the following chart. The reason to do this is that the cables are

a structured part of the house and will not be moved. Components are not structured, may be changed, re-cabled, disconnected, etc.

and should not be used to identify functioning of cables.

Label: Location: Label: Location

V1 Family Room South Wall RG6 T18 Master Bedroom West Wall Category 5 or 5e

______ ________________________________________ ________ _________________________________ _________

______ ________________________________________ ________ __________________________________________

Telephone Distribution Module

Telco Lines from Demarcation Point:

A: __________ B: __________

C: __________ D: __________

A B C D

A or A/B C D

RJ31X

For Alarm

Override

Expansion

Port

to Telco

Distrib.

to Line Ports

From Demarcation Point

From Telco

Demarcation

point

Out to

Rooms

Cabled to:

1: ____________

2: ____________

3: ____________

4: ____________

5: ____________

6: ____________

7: ____________

8: ____________

9: ____________

Bridged Voice Module

Telco Lines from

Demarcation Point:

A: ________

B: ________

C: ________

D: ________

Cabled to:

1: _______________

2: _______________

3: _______________

4: _______________

5: _______________

6: _______________

Data Module

(selected panels only)

Label each

cable

Cables to

rooms

Installation Manual