Installation manual

9.4 Enhanced Infrastructure
The Enhanced Infrastructure Platform serves network-
ing and its multiple PCs as well as multi-room
audio/video requirements. Security cameras and home
theaters are also included in this platform that uses an
SMC-420 as the distribution center.
9.4.1 Telephone Connections Using Telephone
Distribution and Category 5 Voice and
Data Modules
Leviton offers two components for superior voice and
data connections in its Enhanced Infrastructure Platform
as part of the Advanced Small Office Unit Panel:
1. Telephone Distribution Module that distributes up to
four (4) lines throughout a home or office in combi-
nations of Line 1 & 2, Line 3, or Line 4. This module
does not stand alone, but connects to the Category
5 Voice and Data Module with patch cords for easy
changes. The Telephone Distribution Module acts as
the initial connecting point for incoming phone lines.
It comes with two service bridge jacks that when dis-
connected allows isolation of the home internal
wiring and serve as a test port for the entire module.
The upper jack can be used to test the incoming dial
tone for all incoming lines. The lower jack is con-
nected to all of the patching jacks on the module. An
expansion port is available for connecting to a sec-
ond Telephone Distribution Module, thus supporting
the cascading of a series of modules.
2. The Category 5 Voice/Data Module is used to add
modular voice/data distribution. It can be used as a
stand-alone Category 5 distribution device for data, or
to distribute voice over Category 5 or 5e cables to
wallplate locations.
Note: Do not place any patch cord or test cable into the gray
RJ31X jack as the tines in this jack can be bent out of shape.
Use only a security system patch cord (RJ31X cord) for this
connection.
It’s worth repeating: To avoid removing too much of the
jacket from the first (blue) or last (brown) wires, install
either the orange (#2) or green (#3) wire first at the
punch down block. This helps to center the cable.
Otherwise, if the blue pair is installed first and terminat-
ed close to the cable, the brown pair will extend further
than the one-half inch from the jacket and therefore be
more exposed than the standard calls for. Remember,
the more exposure, the greater the chance for a sub-
standard installation.
For more information call your Leviton representative or the Leviton Technical Hotline at 800-722-2082
© Copyright 2001 Leviton Manufacturing Co., Inc.
Installation Manual
9
TRIM OUT
Installation
Trim Out
9-6
Advanced Small Office (ASO) Unit
Dial Tone #1 - M ain Home Line
Dial Tone #2 - Business Line
Dial Tone #3 - FAX Line
Dial Tone #4 - Kids’ Line
Telephone
Distribution
Module
Optional Security
System interface
(RJ31x Jack)
Service Bridge 
Jacks and Jumper
Expansion
Jack
Dial Tone #1
Dial Tone #2
Dial
Tone #3
Dial Tone #4
Category 5 Cable
Phone Patch Cords
Line 1
Fax - Lin
Category 5
Voice and
Data Module
Line 1 & 2 on 
2-Line Phone
Line 4
Telephone
Distribution
Module
Cat 5 Voice/Data
Module
1x6 Video Splitter