Instruction manual

7
SELECTING A DIFFERENT FOLDER
• Press FOLDER UP for 2 seconds. When the display unit flashes, press NEXT or BACK
to select the desired folder.
• To select the previous files, press FOLDER DOWN.
(Comment: the FOLDER UP/DOWN function can only be activated if the disc contains
at least 2 files)
SEARCHING FOR A PASSAGE ON A TRACK
1. Press and hold BACK or NEXT to read the track in fast forward mode at reduced
volume.
2. When you have found the desired passage, release the BACK or NEXT
button(normal playback resumes automatically).
MODE
Repeat: play back of the current track continuously.
Repeat all: play back of the entire CD continuously.
Album: playback of selected folder continuously.
Random: playback in random order continuously.
PROGRAMMING OF TRACK NUMBERS
Up to 20 tracks can be programmed in any order. If desired, a given track can be
programmed more than once.
1. In STOP mode, press BACK or NEXT to select a track.
2. When the desired track number appears press the PROG button once to record the
track (the display unit displays "prog", briefly followed by the track number selected).
3. Repeat steps 1 and 2 to select and program the desired tracks.
4. To start playback of your programmed tracks, press PLAY/PAUSE.
PROGRAM CHECK
In STOP mode, press the PROG, button, (the display unit displays the track numbers in
the order programmed).
DELETING A PROGRAM
Perform the following operations to delete the memory:
• Open the CD door;
• Select the RADIO source;
• Press STOP once.
USE WITH A USB KEY
1. Slide the FUNCTION SELECTOR to CD/MP3/USB.
2. Insert your USB key into the USB socket.
3. Press and hold PLAY/PAUSE for 2 seconds to switch from CD/MP3 mode to USB mode.
The display unit shows:
(USB MODE)
4. Start playback by pressing PLAY/PAUSE.
5. To stop playback, press STOP.
Press PLAY/PAUSE again for 2 seconds to return to CD/MP3 mode.
The display unit shows:
(CD MODE) (MP3 MODE)
NOTE: Before removing your USB key, press STOP then press and hold PLAY/PAUSE
for 2 seconds to return to CD/MP3 mode.
MAINTENANCE & SAFETY
OPERATING PRECAUTIONS AND GENERAL MAINTENANCE
• Place the unit on a hard and plane surface to ensure that it does not tip over.
• Do not expose the unit, batteries or the CDs to humidity, rain, sand or an excessive
source of heat from a heater or direct sunlight.
• No not open the apparatus. A gap of at least 15 cm must be kept between the
ventilation openings and the surrounding surfaces in order to ensure sufficient
ventilation and avoid all accumulation of heat.
EN
Instruction Manual