Operation Manual

8
PROGRAM CHECK
In STOP mode, press the PROG, button, (the display unit displays the track numbers in
the order programmed).
DELETING A PROGRAM
Perform the following operations to delete the memory:
• Open the CD door;
• Select the RADIO source;
• Press STOP once.
USE WITH A USB KEY
1. Slide the FUNCTION SELECTOR to CD/MP3/USB.
2. Insert your USB key into the USB socket.
3. Press and hold PLAY/PAUSE for 2 seconds to switch from CD/MP3 mode to USB mode.
The display unit shows:
(USB MODE)
4. Start playback by pressing PLAY/PAUSE.
5. To stop playback, press STOP.
Press PLAY/PAUSE again for 2 seconds to return to CD/MP3 mode.
The display unit shows:
(CD MODE) (MP3 MODE)
NOTE: Before removing your USB key, press STOP then press and hold PLAY/PAUSE for
2 seconds to return to CD/MP3 mode.
MAINTENANCE & SAFETY
OPERATING PRECAUTIONS AND GENERAL MAINTENANCE
• Place the unit on a hard and plane surface to ensure that it does not tip over.
• Do not expose the unit, batteries or the CDs to humidity, rain, sand or an excessive
source of heat from a heater or direct sunlight.
• No not open the apparatus. A gap of at least 15 cm must be kept between the
ventilation openings and the surrounding surfaces in order to ensure sufficient
ventilation and avoid all accumulation of heat.
• The unit's mechanism features self-lubricating bearings and thus do not require
grease or lubrication.
• Use a soft and dry cloth to clean the unit. Never use cleaning agents containing
alcohol, ammonia, benzene or abrasives, which may damage the cabinet.
CLEANING CDs
• Use a soft and clean cloth to wipe away fingerprints or dust from the surface of
the disc.
• Wipe in a straight motion from the center to the edge. Very small dust particles
and slight smudges have absolutely no effect on the sound quality.
• Never use chemical products such as sprays for conventional (vinyl) records, anti-
static aerosols, benzene or thinners to clean your CDs.
• To reduce the risk of scratches, always store CDs in their case when not used.
• Do not expose CDs to direct sunlight, high humidity or excessively high
temperatures for long periods of time.
• Never write or affix labels to the CD's surfaces.
CLEANING THE LENS
If the lens is dirty, the sound may skip and the CD may not be read correctly. Open
the CD door and clean the lens as follows:
• Unplug the power cord.
• Dust or dry particles:
Blow on the lens several times using a camera lens brush, then wipe it gently with
the brush to remove the dust. Then blow again on the lens.
Instruction Manual