Operation Manual

Radio operation
- Press the ON / OFF button (7) to turn the radio on.
- Set the AM/FM BAND switch (8) to the desired waveband.
- Select the station by using the TUNING knob (14).
- Turn the VOLUME knob (12) to adjust volume as required.
- Press the ON / OFF button (7) again to turn the radio off.
Notes:
- The AM band uses an internal directional aerial, rotate the radio for best
reception.
- Ensure that the FM antenna (18) is completely unrolled and extended for best
FM reception.
Line in jack
The LINE IN jack (11) can be used to playback alternate audio signal sources
on the unit speakers. This LINE IN jack (11) requires a 3.5mm audio cable for an
input signal (3.5mm audio cable is not included).
Specifications
Frequency : AM 530 – 1600 kHz
FM 87,5 – 108 MHz
Battery backup : 2 x 1,5V AAA battery (not included)
Power source : AC230V ~ 50Hz, 5W
Reset
The RESET button (20) is located on the back of the unit. Use a ballpoint pen to
press the RESET button (20) whenever you change the batteries, or when the
unit is not performing as expected. This will return all settings to the default value,
you will lose any stored data (alarm and clock settings).
Alarm battery back-up system
This clock radio includes a alarm battery back-up circuit that can wake you up
even if the power is ‘off’ at the selected wake up time. The clock display will
be off and the radio will not operate, but a separate mini-buzzer will turn ‘on’
automatically to wake you up, even if you had selected the ‘wake to radio’ option.
The alarm will sound for 30 seconds and then shut off automatically. To stop the
alarm buzzer immediately, press the power ON / OFF button (7). Pressing the
SNOOZE / SLEEP / NAP button (4) has no effect during battery back-up alarm
operation.
GB-5