Operation Manual

Radio operation
- Press the ON / OFF button (12) to turn the radio on.
- Set the AM/FM BAND switch (11) to the desired waveband.
- Select the station by using the TUNING knob (8).
- Turn the VOLUME knob (7) to adjust volume as required.
- Press the ON / OFF button (12) again to turn the radio off.
Notes:
- The AM band uses an internal directional aerial, rotate the radio for best
reception.
- Ensure that the FM antenna (23) is completely unrolled and extended for best
FM reception.
Aux in jack
The AUX IN jack (19) can be used to playback alternate audio signal sources
on the unit speakers. This AUX IN jack (19) requires a 3.5mm audio cable for an
input signal (3.5mm audio cable is not included).
Specifications
Frequency : AM 530 – 1600 kHz
FM 88 – 108 MHz
Battery backup : 1 x 3V CR2032 (fl at) lithium battery (not included)
Power source : AC230V ~ 50Hz, 5W
Reset
The RESET button (20) is located on the back of the unit. Use a ballpoint pen to
press the RESET button (20) whenever you change the batteries, or when the
unit is not performing as expected. This will return all settings to the default value,
you will lose any stored data (alarm and clock settings).
Projection unit
- Focus setting: to adjust the brightness / focus of the PROJECTION UNIT (17)
use the FOCUS ADJUSTMENT FOR PROJECTION UNIT (18) until the
projected time is clearly shown on the ceiling or wall.
- To fl ip the projected image by 180°, press the PROJECTION TIME 180° FLIP
button (14).
Notes:
- Projects time image on the ceiling or wall of a darkened room.
- Ideal projection distance is 3-9 feet/1-3 meters.
GB-5